Microe 1000 Mercury Bedienungsanleitung

Mercury™1000AAnnaalloogg OOuuttppuutt EEnnccooddeerr SSyysstteemmIInnssttaallllaattiioonn MMaannuuaall aanndd RReeffeerreennccee GGuuiiddeeManu

Installation Reference GuidePage 8MicroE SystemsL0.2L0.6L0.2LBenching pinsPositioning the ScaleNote: Before beginning mounting procedure, use talc-fr

Page 9Installation Reference GuideSensor mounted with good electrical contact to a well-grounded surface (preferred)1. 15-pin D-sub connector groundi

Page 10Customer Interface Cable RequirementsCustomer cables that interface to Mercury series encoders must have the following characteristics:• Twis

TroubleshootingProblemThe Power/Calibration indicator will not come on.Solution• Make sure the M1000 15-pin D connector is fully seated and connected

World Headquarters: 125 Middlesex Turnpike • Bedford • MA 01730 USAwww.microesys.com • [email protected] • T. [781] 266-5700 • F. [781] 266-

IInnttrroodduuccttiioonnMicroE Systems was founded to advance encoder technology toa level never before achieved. Our objective was to design encoders

TTaabbllee OOff CCoonntteennttssSYSTEM ILLUSTRATION PAGEEncoder with Linear scale 2Encoder with Rotary scale 3INSTALLATION INSTRUCTIONSEncoder Syste

Mercury 1000 Analog Encoder System with Linear scaleEExxppaannddeedd VViieewwEnd locator pinSensor mounting holes (2)Bracket mounting holes (2)Option

Mercury 1000 Analog Encoder System with Rotary scaleSSyysstteemm VViieewwShown with rotary scale15 pin standard D-sub connectorEExxppaannddeedd VVii

Installation InstructionsLinear Encoders12Attach the scale to the base slide. Reference the preferreddatum on the interface drawing for either end or

Installation InstructionsLinear EncodersProper sensor alignment may require minor adjustments to the sensor position withrespect to the scale. This ca

Installation InstructionsRotary EncodersAttach your hub/scaleassembly to the rotarydevice. Refer to theinterface drawing. Thereflective surface of the

IIMMPPOORRTTAANNTTOOUUTTPPUUTT CCAALLIIBBRRAATTIIOONN PPRROOCCEEDDUURREEThis procedure must be completed forproper system operation each time thesen