Microe 3500V Mercury Bedienungsanleitung Seite 1

Mercury™2000V & 3000V- Vacuum RatedSSmmaarrtt PPrrooggrraammmmaabbllee EEnnccooddeerr SSyysstteemmssIInnssttaallllaattiioonn MMaannuuaall aan

Reference SectionInstallation of Linear Scales Page 8MicroE SystemsL0.2L0.6L0.2LBenching pinsPositioning the ScaleNote: Before beginning mount

Reference Section Grounding Instructions for Mercury 2000V and 3000V Encoder SystemsPage 9Customer Differential Line ReceiverRecommended Interface Te

Reference Section Page 10Mercury 3500, 3000, 2000 Signal Twisted PairA+ Pair 1A-B+ Pair 2B-Index+ Pair 3Index-+5V Pair 4GNDCustomer Interfac

SmartPrecision Module Mounting OptionsThe SmartPrecision electronics module may be mounted directly to a bulkhead connector using the integral thumb s

World Headquarters: 125 Middlesex Turnpike • Bedford • MA 01730 USAwww.microesys.com • [email protected] • T. [781] 266-5700 • F. [781] 266-

IInnttrroodduuccttiioonnMicroE Systems was founded to advance encoder technology toa level never before achieved. Our objective was to design encoders

TTaabbllee OOff CCoonntteennttssSYSTEM ILLUSTRATION PAGEEncoder with Linear scale 2Encoder with Rotary scale 3INSTALLATION INSTRUCTIONSEncoder Syste

Mercury 2000V & 3000V Encoder System with Linear scaleFlying Leads (to be connected to inside ofvacuum chamber pass through connector)Sensor(shown

Mercury 2000V & 3000V Encoder System with Rotary scalePage 3Double shielded “pigtail” cable from vacuum wall to electronicsEExxppaannddeedd VViie

Installation InstructionsLinear Encoders2Attach the scale to the baseslide. Reference the preferreddatum on the interface drawingfor either end or cen

Installation InstructionsLinear Encoders5If benching dimensions cannot be provided, proper sensor alignment may require minor adjustments to the senso

Installation InstructionsRotary EncodersAttach your hub/scale assemblyto the rotary device. Refer tothe interface drawing. Thereflective surface of t

Installation InstructionsRotary EncodersPage 76Confirm proper alignmentover the full range of motion. The “Proper Alignment” LEDmust remain on over th