Microe OPS Series Bedienungsanleitung PDF herunterladen (Seite 17)

Page 17

Sensor Calibration - by SmartPrecision™ II Software

OPS

™

Series Encoders, Side and Top Mount Configurations

Click appropriate

checkboxes before

calibrating:

Calibrate GOP

Calibrate Index

Set Left Limit

(optional)

Set right Limit

(optional)

Note: all procedures below must be performed at ≤1m/s relative motion between the sensor and

the scale.

Move the sensor

back and forth

(Gain Offset

Phase).

NOTE:

Correct orientation of the scale for Left/Right Limit calibration is shown below. The

“D” datum edge from the OPS Interface Drawing is designated as the “Top” of the

scale. The Index/Limit track is also the “Top” track on a scale (tape and glass).

“D” datum edge of scale = “Top” of the scale.

Index/Limit Track

“Left” side of scale

“Right” side of scale

Move the sensor

back and forth

over the Index

until the Left

Limit blue light

turns on. (The

Index is now

calibrated.)

Click Start Cal

button.

Note: It is important that if you choose to calibrate only the limits, the sensor must be

placed in the “no limit” area of the scale (neither the left or right limit) when you click the

“Start Cal” button.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Keine Kommentare

Microe OPS Series Bedienungsanleitung Seite 17